![]() ![]() I know there are a lot of threads about boot loops and I have tried some fixes indicated but I'm starting to be less sure about where to go now.Īny advice on what to try next would be greatly appreciated. I guess there is also the GPU tray to try replacing. I do not have another Mac to test for faulty components. trying to get the computer on long enough to get a boot disk in (I have Snow Leopard on CD). removing the hard drive and trying to boot with another drive with a clean OS X (I have a friend who might be able to provide this) orģ. look at the log - I should have grabbed them while I could have) and shut down properly after about 5 minutes of running.Ģ. Often, when I manage to log in, if I try to do something (like click on an icon so the computer does something) that triggers an immediate fail (shutdown and attempted reboot).Īfter I replaced the CPU I thought I was making progress because I was able to: reset the NVRAM, navigate in the computer a bit (e.g. I thought it might be leaky caps and was sure it was going to be the power supply. ![]() It sometimes runs for a little while longer (chimes and gets through to log in) if left off for a couple of days, but this is not very predictable. ![]() None of these things appear to be the source of the problem as the issue is still occurring. I have tried replacing all of the RAM, replacing the CPU and replacing the power supply (as of today). I literally have to pull the plug to stop the boot loop. I can sometimes log in and it runs for a little while, but other times it starts, fans work, and then it directly enters the loop. It supports Plugins, which are community-contributed modules that provide a basic bridge from HomeKit to various 3rd-party APIs provided by manufacturers of 'smart home' devices. I thought it might have been triggered by dust. Homebridge is a lightweight NodeJS server you can run on your home network that emulates the iOS HomeKit API. I then did not use the computer for several months (I was finishing building a console) and when I tried starting it up a boot loop issue appeared. I thought I'd give replacing the back plane a go and that worked and it was up and running again. Long story short, I took it to a repairer who couldn't get it started said junk it (I live in NZ in the provinces on the edge of nowhere). I use it (used it) to interface with legacy ADDA converters and recording software. Hello everyone, I have a Mac Pro 5,1 (mid 2012 4-core) that I picked up a while ago. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |